Product Description
Klein Tools VDV826-705 is a 50-pack of shielded RJ45 CAT6A pass-through connectors, built for CAT6A shielded twisted pair (STP) cable on Gigabit and 10 Gigabit runs.
Where this fits on a job
On CCTV IP installs, camera runs and switch/patch panel terminations are where most connector failures happen. This pack gives an installer enough shielded plugs to terminate a full run of cameras across a retail unit, warehouse or office floor without stopping mid-job to reorder.
Typical pairings: CAT6A STP cable, IP cameras, network switches, patch panels, routers and NVRs — all listed compatible uses for this connector.
Why pass-through and why shielded
The pass-through design lets conductors run fully through the connector body before crimping, so wire order can be checked visually before the crimp is committed — reducing miswires on multi-run jobs. The shielded metal housing is built to cut electromagnetic interference, relevant where cable runs sit near power lines or other noisy equipment on commercial sites. Contact pins are gold-plated for consistent conductivity.
Key specs
- Connector type: shielded RJ45, CAT6A pass-through
- Cable compatibility: CAT6A STP, and large CAT6 cable
- Network support: Gigabit and 10 Gigabit Ethernet
- Contacts: gold-plated
- Pack size: 50 connectors
Suited to CCTV installers, network technicians and structured cabling contractors specifying connectors for shielded runs across multi-camera or multi-port deployments.
Specifications
- Brand
- Klein Tools
- Connector Type
- RJ45 male, pass-through
- Cable Category
- CAT6A
Technical Specifications
Frequently Asked Questions
Which cable is the VDV826-705 designed to be used with?
CAT6A shielded twisted pair (STP) cable, including large CAT6 cable.
What network speeds does it support?
It supports Gigabit and 10 Gigabit Ethernet applications.
How many connectors are in a pack?
Each VDV826-705 pack contains 50 connectors.
What is the pass-through design for?
It lets conductors pass fully through the connector before crimping, so installers can check wire alignment for accurate termination.
