Product Description
The 4 Port Gigabit POE Extender 1000M Network Switch Repeater IEEE802.3af/at Plug&Play for PoE Switch NVR IP Camera AP (GoodTop, SKU PoE-Extender-Repeater-4-Port-Gigabit-1000M, also listed as POE013GS) adds 100m (328ft) of PoE power and data to a run that has reached its cable limit.
Where it fits on a job
Use it when a camera or access point has to sit further from the NVR or PoE switch than a single cable pull allows, such as the far end of a warehouse or a back-office wing. With 3-level cascade, one uplink can branch out to several positions instead of needing several long home runs.
Specs to plan around
- 1 input, 3 output ports, 10/100/1000 Mbps auto-adaptation
- IEEE 802.3af/at
- Input up to 30W; total output 25W; up to 15.4W per output port
- VLAN isolation on output ports 1-3
- Plug and play, no configuration
- Wall mount
Before you specify
It has no power supply of its own, so a PoE device must feed it first. Budget against the 25W total output, not three times 15.4W. Use Cat5e as a minimum; Cat6 is recommended for data transmission and power stability.
Specifications
- Brand
- GoodTop
- Product Type
- Gigabit PoE extender
- Total Ports
- 4 × RJ45
- Input
- 1 × PoE input port
- Outputs
- 3 × PoE output ports
- Network Speeds
- Auto-adaptive 10/100/1000 Mbps
Technical Specifications
Frequently Asked Questions
Does this PoE extender need its own power supply?
No. It has no power supply of its own, so connect it to a PoE device first.
What is the power budget?
Maximum input is 30W and total output is 25W. Each output port delivers up to 15.4W.
Which cable should I use?
Use Cat5e at minimum. Cat6 is recommended for data transmission and power stability.
Can it be cascaded?
Yes, it supports 3-level cascade, which can reduce wiring difficulty on remote deployments.
